Unify OpenStage 40 SIP

118 Making calls with multiple lines
Making calls with multiple lines
You can use your OpenStage 40 as a multi-line phone. If you have any questions
regarding how to configure your OpenStage phone as a multi-line phone, please
contact your administrator.
The following is a description of the telephony scenarios for multi-line phones.
To facilitate comprehension, you should familiarise yourself with the enhanced
telephony application and how to use the line keys beforehand. Furthermore,
you can specify individual settings for your multi-line telephone. Refer to the fol
-
lowing sections for a detailed description of the individual components:
• Introduction to multi-line phones  Page 13
• Lines and line keys
 Page 21
• Multi-line telephony interface
 Page 28
• Individual settings
 Page 133
Incoming calls
Depending on your individual settings, you will be notified of incoming calls
 Page 182.
Accepting calls for the primary line
In this case, the telephone behaves in the same way as a single-line telephone.
See
 Page 38 and  Page 82.
Accepting calls for secondary lines
Prerequisite: The secondary line is configured on your multi-line telephone.
Using the handset
^ Lift the handset.
[ Conduct call.
Using the line keys
T Press the flashing line key.
Speakerphone mode.
Select and confirm the option shown.
Speakerphone mode.
The line used for the ringtone is selected automatically. If there are calls
on several lines, you are connected with the line that has been ringing the
longest.
Accept