Call recording 197
Enhanced functions:
1. A conference
1
can be set up or cleared down during recording.
2. A consultation can be performed during recording.
3. Call transfer is also available during recording.
4. A second call can be accepted during recording.
The following features are not supported:
1. Playing back recordings over the telephone.
2. Deleting recordings over the telephone.
3. Functions for editing recordings over the telephone.
Recording tips
You will receive the following advisories while a call is being recorded:
• The recording symbol | on the display (permanent)
• Beep (repeated at intervals for you and your call partner)
• Beep (single at the start of recording for you and your call partner)
The audible advisory can also be switched off. Please check with the relevant
administrator.
Multiline
In terms of call recording, no distinction is made between multiline and single-
line. If recording has started, recording is performed, otherwise not. The record-
ing status of a line persists as long as calls are connected to this line.
For example, if line A is being recorded (initiated manually) and you switch to
line B or line A is placed on manual hold and you switch to line B, the recording
is ended and a partial recording saved.
If you disable recording for the call on line B (mode = manual or auto start) and
switch back to line A, the recording for line A is not started again.
The modes mentioned (All Calls, AutoStart or Manual) refer to the telephone and
are therefore the same for all lines.
Recording conversations
Using the call recording feature
The recording function can be used in a similar way to a recorder, for example
for recording music. The recorder can be:
• switched on (standby .)
• switched off or stopped (~)
•started (/)
• paused (@)
The symbols used here by way of example can be found on practically any hard-
ware and software recorder.
1. Server-based conference only
To Next Page
Loading...
Need help?
General