Unify OpenStage 40 SIP

Enhanced phone functions 93
Connecting parties
Prerequisite: You have accepted the second call.
Select and confirm the option shown in the active connection’s context menu.
The other two parties are now connected to one another. You can now hang up
or dial another number for instance.
or Connect by hanging up
Prerequisite: Connecting by hanging up is activated (ask your administrator)
and "Switch assignment" must be set to "Yes" (
 Page 94). Before you can be
connected by hanging up you must have toggled at least twice ( Page 54).
] or n Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. The other two parties are now connected to one another.
Allowing call waiting
Prerequisite: The option was programmed by your administrator.
z
You can also configure this setting via the WBM interface  Page 206.
N Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
if nec.j Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Assuming Allow call waiting is generally activated, you can toggle the config-
ured sensor key to switch call waiting on/off ( Page 93).
Complete Xfer
If the Call waiting (second call) function is deactivated, a caller hears the
busy signal if you are already conducting a call.
Settings
User
Configuration
Incoming calls
Handling
Allow call waiting
Yes
Save & Exit