Unify OpenStage 40 SIP

98 Enhanced phone functions
Beep on auto-reconnect
You can reconnect a held call both via the CTI application and via the phone. A
beep sounds when you toggle between an active call and a held call when the
function is active.
Prerequisite: The option was programmed by your administrator.
z
You can also configure this setting via the WBM interface  Page 206.
N Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
if nec.j Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Settings
User
Configuration
Incoming calls
CTI calls
Beep on auto-unhold
Yes
Save & Exit