Cautions and Requests for Use
Cautions and Requests for Use
● Do not disassemble the main body for modifications or repair.
● Be sure to use crimp contacts for connection to terminal blocks, and do not to
connect bare wires as they are.
● Be sure to ground the protective ground terminal.
- The main F.G. is indicated by , it must be grounded with the protected
earth.
● Be sure to disconnect the power cable when performing the following.
- Attachment/detachment of connectors of options.
- Wiring/connection of cables to terminal blocks.
- Connection of the ground line.
● Be sure to assort the machine which is supplied by AC power through the ter-
minal in a panel with lock or screws.
● Carefully check wiring, etc. before applying power.
● Take an interval of more than 5 seconds when repeating ON/OFF.
● Take adequate shielding measures when using at the following locations.
- Near a power line.
- Where a strong electric field or magnetic field is formed.
- Where static electricity, relay noise or the like is generated.
● Do not install in the following environments.
- Placeｓ exposed to direct sunlight.
- Where the temperature and/or humidity exceeds the range in the
specifications.
- Placeｓ containing corrosive gas or flammable gas.
- Placeｓ with large quantities of dust, salt or iron powder.
- Where the product may be splashed with water, oil or chemicals.
- Where the main body is directly affected by vibration or shock.
● Set the correct Excitation Voltage for the sensor. （2.5V is set when F371 is
dispatched from us.）
To Next Page
Loading...
Need help?
General
