O P E R ATIN G A N D O PE R AT I O N
105
W L 3 0
Now raise the loader lift arms slightly so that the weight is
on the loader‘s front axle. This is to avoid excess wheel
slip. You can also manually restrict wheel slip by inching.
To ll the bucket, curl the bucket as shown in Fig. 43 as the
loader arms are slowly raised. Carry the loaded bucket in
this position to the location or truck where the material in
the bucket is to be deposited.
Carry the loaded bucket low until necessary to lift it to the
necessary loading height.
If material is to be loaded which the bucket cannot easily
penetrate, you can create an up-and-down movement of
the bucket cutting edge by alternately curling the bucket
slightly upward and downward while penetrating into the
material. This makes it easy for the bucket to penetrate the
material (Fig. 44).
Fig. 43
Loading work 2
Fig. 44
Loading work 3
To Next Page
Loading...
Need help?
General
