S E R V I C I N G A N D I N S PE C T I O N
169
W L 3 0
Servicing the water separator
1.
Place a receptacle under the water separator Item 1
(Fig. 70).
2. Unscrew the drain plug from the inspection glass Item
a (Fig. 70).
3. The collected water now runs out.
4. Retighten the drain plug when the collected water has
run out.
Check the lter screen in the water separator. If required:
5. Remove the inspection glass and clean it.
6. Clean or replace the lter screen.
7. Screw the inspection glass back on.
1
a
Fig. 70
Water separator
To Next Page
Loading...