EasyManuals Logo

Wacker Neuson WL 30 User Manual

Wacker Neuson WL 30
246 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
B A S I C S A F E T Y I N S T R U C T I O N S
22
2.3.2 Safety instructions for other operating modes
These safety instructions refer to special tasks relating to the
use of the loader and servicing tasks - as well as emergency
maintenance during operation or work concerning disposal
of the auxiliary and operating materials.
The Operator’s Manual provides adjustment, mainte-
nance and inspection information and schedules in
subsequent sections. This information is essential to
ensuring peak performance satisfaction and safety over
the life of the wheel loader.
This Operator’s Manual provides routine adjustment
and maintenance procedures in addition to operating
instructions. Diagnosis and repair of the wheel loader
requires special skill, training and tools. Your Wacker
Neuson dealer has the trained technicians to perform
such work safely and effectively.
Maintenance and repair work shall be performed by
operators and technicians trained and knowledgeable
of the wheel loader function and attachments.
Do not attempt to perform maintenance or repair on the
wheel loader until the machine and engine is stopped
and all attachments are in a stable position. Do not at-
tempt to perform maintenance or repair work on hot
surfaces or components of the machine. Read and un-
derstand the procedure for maintenance and repair in
the Operator’s and Repair Manuals for this wheel loader.
Secure the maintenance area, allowing as large a space
as required.
If the loader is being completely shut off during servicing
and maintenance work, please observe the following
(see the chapter »Securing the Loader«):
- Secure the loader from being accidentally turned back
on by removing the starting key.
- Attach a warning note to indicate that the loader is be-
ing worked on.
-
Only perform servicing and maintenance work if the
loader is parked on an even, hard surface and secured
from rolling away and articulating at the steering swivel
point..
-
Before performing work with the loader arms raised,
install the support provided to prevent the loader arms
from lowering suddenly and inadvertently.
- This device shall conform to ISO 10533.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson WL 30 and is the answer not in the manual?

Wacker Neuson WL 30 Specifications

General IconGeneral
BrandWacker Neuson
ModelWL 30
CategoryFront End Loaders
LanguageEnglish

Related product manuals