B A S I C S A F E T Y I N S T R U C T I O N S
28
2.4.5 Gas, dust, steam, smoke
•
Diesel engine exhaust emissions are toxic in concen-
trated amounts. Do not operate the wheel loader in en-
closed spaces or inadequately ventilated spaces.
•
Determine and follow regulations regarding safe opera-
tion at the specic work site.
- Do not operate the wheel loader near open ames.
-
Do not perform welding repairs in explosive atmo-
spheres.
-
Do not weld fuel reservoirs or fuel system components.
- Do not perform any welding operation unless qualied
to do so.
•
Wear appropriate personal protective equipment (breath-
ing lter, protective suit) for protection against specic
dangers, e.g. poisonous gases, corrosive steam, poison-
ous (i.e. containing toxins) surroundings, etc.
2.4.6 Hydraulics, pneumatics
• When detected, oil leaks shall be repaired to avoid:
- environmental hazards
- re hazards
- slip hazards
- explosion hazards
- personal injury hazards.
•
Do not attempt to repair a hydraulic system or component
until the hydraulic pressure has been relieved. Relieve
the pressure by activating controls as advised in this
Operator’s Manual or the Repair Manual.
• Replace hydraulic lines and ttings with original equip-
ment parts from your Wacker Neuson dealer to assure
original performance and safety. The reinstalled hy-
draulic line routing and attachment shall conform to the
original routing. Conrm that the replacement routing
is not interfering with other parts, chang across sharp
surfaces or resting on or near hot surfaces.