S E R V I C I N G A N D I N S PE C T I O N
131
W L 3 0
Securing the loader and attachment
•
Perform servicing and inspection work only if the loader is secured as described in the chapter »Securing
the loader«.
• Crushing hazard. An improperly supported loader lift arm may fall unexpectedly.
•
Do not perform maintenance or service tasks under raised loader lift arms until the loader lift arm support
device (ISO10533) has been inserted and locked between the hydraulic lift cylinder end and the loader lift
arm to prevent any movement of the loader lift arms during maintenance and service.
• Extensive repair information is provided in the separate Repair Manual.
•
Position the attachments on the ground so that no movements can occur when mechanical or hydraulic con-
nections are released.
•
Do not attempt any service repair requiring the technician to perform the work standing in the articulated
steering crush zone. Do not repair the hydraulic steering cylinders or remove the hydraulic lines until the
articulated frame lock has been installed to prevent inadvertent steering movement.
• Secure equipment or components that are to be attached or removed, or whose installation position is to be
changed, to prevent them from unintentionally moving, slipping or falling, by means of suitable lifting gear, or
suspension or support equipment.
• Clean dirt from steps and handles and keep them ready for use.
To Next Page
Loading...
Need help?
General
