WIESHEU IS 600 E - Program Management and Settings; Modifying Running Program Settings

Page 13
Exclusive and IS 600 E · 9401-191-003-EN · Version 18-01
The “1/2” half load option allows you to save energy if the oven is not
completely lled.
On starting a program, the system shows “1/2” on the display for about
10 seconds.
■ If required, choose the half load “1/2” icon within the first ten sec-
onds of starting the program.
→ The “1/2” symbol appears on the display.
You can retrot the IBC option, which replaces the half load function. Regardless of the
load amount that your process, it is always possible to bake it with the same baking
program. In each case, IBC automatically determines and regulates the respective
temperature that is needed.
Please note that the half load function is not displayed in conjunction with the IBC op-
tion.
5.3.1 Half load (not in conjunction with IBC)
Baking off?
Yes
No
Yes
?
Yes
?
Change the set values during the running program.
■ Use the slider/rotary button to choose the setting that you want to
change.
■ Change the setting.
→ The program continues to run with the changed settings.
The settings/parameters that you can change in the individual programming steps are
described in the chapter entitled “Overview of settings in the different program/baking
steps”. Changes during the running program are not saved.
5.3.2 Changing the settings/parameters in the running program
5.3.3 Baking off
Activate “Baking off” if the baking result is too light for you.
→ At the end of the program run, the system issues an audible
signal.
→ The system shows the following message on the display: “Baking
off?”