WIESHEU IS 600 E - Blinken bei Reinigung Ende; Sound

Version 18-01 · 9401-191-003-EN · Exclusive and IS 600 E
Page 36
2017-01-11
15:32:15
Button volume
General volume
Signal time
Sound table
Sound
Make various settings relating to the audible signal. Set the volume of
a sound. Assign an acoustic signal to a specic event. Set the duration
of the signal. Set a tone / sound from a table of different WAV les.
You are in the “Operator settings” menu item.
■ Use the slider / rotary button to select the “Sound” menu.
The following submenus are displayed in the “Sound” menu:
● Button volume
● General volume
● Signal time
● Sound table
12.2 Sound
12.1.1 Flashing at end of cleaning
The following settings are possible:
● Off
● 1 sec - 600 sec (seconds)
● Always on
■ ”Always on” setting.
→ The light signal is activated.
→ At the end of the cleaning program, the oven lighting ashes
permanently until you acknowledge the message.
or
■ 1 sec - 600 sec (seconds) setting
→ At the end of the cleaning program, the oven lighting ashes for
the set time period.
or
■ ”OFF” setting.
→ The light signal is deactivated.
→ At the end of the baking program, no light signal is issued.
■ Choose your setting.
→ The display shows the message:
”Save changes? Yes / No”
■ Select ”Yes”:
→ The setting is saved.
or
■ Select ”No”:
→ The process is cancelled.
14/08/2017
15:32:15
ashing on RE
Light
Always on
Switch on/off
14/08/2017
15:32:15
ashing on RE
Light
200 sec
Switch on/off
14/08/2017
15:32:15
ashing on RE
Light
Off
Switch on/off
Save changes?
No
Yes
?