03/2003
1-16
8850/ 510DP
Maintenance Procedures
Service Call Procedures
Normal Call Clean the Cutter. To ensure a straight, smooth cut on the lead edge of
the media.
Vacuum the media dust and contamination from the Cutter Blade area.
Table 9 Media Drawers
INTERVAL TASK REASON TASK ENABLER
Normal Call Clean the media drawer. Customer satisfaction. Clean the media dust and contamination from each of the media drawers
with a vacuum cleaner.
400K feet or
122K meters
Lubricate the Roll Feed Media Drawer
Latches (PL 7.5)
Machine operation - ensure that the drawers close
completely.
Lubricate the Roll Feed Media Drawer Latches with very light coating of
lubricant at interval specified.
Table 10 Ozone Filter
INTERVAL TASK REASON TASK ENABLER
Normal Call Check and replace the Ozone Filter if
necessary.
To ensure correct air flow through machine, and to
keep heat that is generated to a minimum.
Check the Ozone Filter at 40K prints, clean or replace as required. Replace
the Ozone Filter at 120K prints.
Table 8 Cutter
To Next Page
Loading...
