Xerox 8850 - REP 10.11 AC Module (A1)

03/2003
4-136
8850/ 510DP
REP 10.9, REP 10.11
Repairs and Adjustments
4. (Figure 4): Remove the Fuser Exit Sensor.
NOTE: The view in Figure 4 is looking under the Fuser Module. On the newer Printers
the Sensor is also mounted with a Spring Clip
Figure 4 Removing the Fuser Exit Sensor
REP 10.11 AC Module (A1)
Parts List on PL 1.1
Removal
1. Remove the Controller and the Rear Covers.
1
Disconnect the connector
4
Remove the Fuser Exit
Sensor from the Housing
2
Remove the Screw and
Spring Clip
3
Remove the Support
Housing