03/2003
4-66
8850/ 510DP
REP 9.5
Repairs and Adjustments
REP 9.5 Developer Module
Parts List on PL 9.6
WARNING
Switch off the Main Power Switch. Disconnect the Power Cord.
NOTE: In the following steps the terms “left” and “right” describe machine locations as
observed when facing the Roll Media Supply Drawer side of the Printer.
NOTE: If the Developer Module is being replaced with a new one, new Developer Material
must be installed. Refer to (REP 9.7) Developer Material.
Removal
CAUTION
Before removing the Developer Module, ensure that there is a clean area on which to place the
assembly.
1. Loosen the screws and open the Rear Cover.
2. Raise and latch the Top Cover.
3. Raise and hold the Developer Module Cover while lifting and removing the Rear Devel-
oper Cover.
4. Lower the Top Cover.
NOTE: In the following step, tape the Toner Cartridge dispense holes in order to prevent toner
from pouring out when the Toner Cartridge is tipped up for removal.
5. (Figure 1): Remove the Toner Cartridge.
Figure 1 Removing the Toner Cartridge
3
Pull the plunger while
performing and remove
the Toner Cartridge
1
Slide the cover
open
2
Clean the toner from the
holes in the dispense area
and place a piece of tape
over the holes
4
Remove the Toner
Dust Trap
To Next Page
Loading...
Need help?
General