03/2003
6-47
8850/ 510DP
8850 Change Tag Information, SPS 510dp Change
General Procedures
8850 Change Tag Information
Introduction
The purpose of this section is to list the Change Tag Index.
All important modifications are identified by a Tag number on a matrix card attached to the
machine.
This section describes all of the Tags as well as multinational applicability, classification codes,
and permanent or temporary modification information.
Classification Codes
A Tag number may be required to identify differences between parts that cannot be inter-
changed, or differences in diagnostic, repair, installation, or adjustment procedures. A Tag
number may also be required to identify the presence of optional hardware, special non-vola-
tile memory programming, or if mandatory modifications have been installed.
Each Tag number is given a classification code to identify the type of change the Tag has
made:
M - Mandatory
N - Not installed in the field
O - Optional
R - Repair
TAG: Not Used
CLASS: S
USE:
MFG SERIAL NUMBERS:
NAME:
PURPOSE:
KIT NUMBER:
REFERENCE:
TAG: 2
CLASS: O
USE: All
MFG SERIAL NUMBERS:
NAME: Developer Heater
PURPOSE: To control the temperature of the developer material to prevent a low tribo con-
dition (Sleep Mode) in high humidity conditions.
KIT NUMBER: 605K11690
REFERENCE: N/A
TAG: 3
CLASS: N/A
USE:
MFG SERIAL NUMBERS:
NAME:
PURPOSE: .
KIT NUMBER:
REFERENCE: N/A
TAG: 4
CLASS: R
USE: All
MFG SERIAL NUMBERS:
NAME: Media Corner Curl
PURPOSE: To provide two guides to be installed on the Stripper Finger Assembly to elimi-
nate damage to the lead edge corners of large media.
KIT NUMBER: 604K12770
REFERENCE: N/A
TAG: 5
CLASS: R
USE: All
MFG SERIAL NUMBERS:
NAME: Fuser Wire Insulation
PURPOSE: To provide a new fuser lamp harness with better insulation properties to with
stand the fuser heat.
KIT NUMBER: 604K12880
REFERENCE: N/A
To Next Page
Loading...
Need help?
General