Xerox 8850 - REP 7.14 Sheet Feed Pinch Rolls

03/2003
4-21
8850/ 510DP
REP 7.14
Repairs and Adjustments
REP 7.14 Sheet Feed Pinch Rolls
Parts List on PL 10.6
Removal
NOTE: In the following steps, the terms “left” and “right” describe machine locations as
observed when facing the Printer from the Roll Media Supply Drawer side of the Printer.
1. (Figure 1): Access the Fuser Module.
Figure 1 Accessing the Fuser Module
2. (Figure 2) Prepare to remove the Upper Sheet Feed Housing from the Fuser.
NOTE: Place your hand under the area where the screws will be removed to support the
Upper Sheet Feed Housing. This will prevent it from falling off the fuser.
Figure 2 Preparing to Remove the Upper Sheet Feed Housing
1
Pull up on the handle and pull
open the Fuser Module Drawer.
1
Support the Upper Sheet Feed Housing from
falling while performing the Step 2
2
Remove the two screws