Xerox COLORQUBE 8870

October 2012
1-10
ColorQube 8570/8870 Service Manual
Cleaning Procedures
Revised, 3rd Revision - Xerox Internal Use Only
Service Call Procedures
Clean the Tray 2/ 3/ 4/ 5 Retard Roller
1. Open the affected Tray.
Figure 3 Opening the Tray
2. Use a moistened cloth to clean the Retard Roller.
Figure 4 Cleaning the Retard Roller
3. Close the affected tray.
NOTE: Clear packaging tape can also be used to clean the Retard Roller.
1. Remove the affected Tray.
2. Peel off a strip of tape. Stretch the tape across the table with the sticky side up. Fasten it
to the table at both ends.
3. Remove the Retard Roller (REP 3.10).
4. Roll the Retard Roller across the tape to remove the debris from the Roller.
5. Install the Retard Roller.
6. Close the affected Tray.