Xerox COLORQUBE 8870

October 2012
4-60
ColorQube 8570/8870 Service Manual
REP 3.8, REP 3.9
Revised, 3rd Revision - Xerox Internal Use Only
Repairs and Adjustments
Replacement
CAUTION
When replacing the I/O Board screws, torque to no more than 12 in.-lbs. Overtightening these
fasteners can result in irreversible damage to the chassis.
Position the corner of the I/O Board behind the Ground Plane before installing the
screws. Be sure to secure the Ground in front of the I/O Board.
CAUTION
Incorrectly mounting the I/O Board may short +3.3V power.
Figure 2 Installing the I/O Board - Correct Ground Plane position in front of the I/O Board
Figure 3 Installing the I/O Board - Incorrect Ground Plane position behind the I/O Board
REP 3.9 Separator Pad Kit
Parts List on PL 3.1 Item 9
Removal
1. Open the Front Door.
2. Pry the Separator Pad towards the front of the printer and lift the Pad away from the
printer.
Figure 1 Removing the Separator Pad