Phaser 6130 Color Laser Printer Service Manual 3-23
Error Messages and Codes
PDL Error
Error relating to Printer Command Language (PCL) has occurred.
Applicable Chain Link
■ Chain Link 016-720: PDL Error
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
3 Check the memory card capacity. Print
the printer Configuration Page: Menu
> Information Pgs > Configuration.
Is the memory capacity correct,
including the optional memory?
Go to step 4. Replace the
Image
Processor
Board
(page 8-60).
4 Replace the memory card. Does the
error still occur?
Replace the
Image
Processor Board
(page 8-60).
Complete.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL8.1.9 “Map 3 - LVPS, Drive Motors, I/P Board, AC
Power” on page 10-10
“Controller” on page 10-31
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the print job.
1.Print a small print job (like a
Windows test print).
2.Does the error still occur?
Go to step 2. Complete.
2 Reseat plugs and jacks on the Image
Processor Board.
Does the error still occur?
Replace the
Image
Processor Board
(page 8-60).
Complete.
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No
To Next Page
Loading...
