Xerox PHASER 6130 - Laser Unit Errors

3-76 Phaser 6130 Color Laser Printer Service Manual
Error Messages and Codes
Laser Unit Errors
Laser Error
An error was detected in the Laser Unit.
Applicable Chain Link
■ Chain Link 061-370: Laser Error (ROS Failure)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ ROS (Laser Unit) Kit, PL4.1.99
■ MCU Board, PL8.2.13
■ “Map 2 - Laser Unit, Feeder Assembly”
on page 10-9
■ “Map 4 - Toner Dispenser Motors, HVPS,
MCU” on page 10-11
■ “Laser Unit” on page 10-22
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the Laser Unit for correct
installation.
Is the Laser Unit correctly installed?
Go to step 3. Reinstall the
Laser Unit. Go
to step 2.
2 Cycle the power.
Does the error still occur?
Go to step 3. Complete.
3 Check the wiring harness connectors
P/J40, P/J41, P/J411, and P/J412
between the MCU Board and the Laser
Unit.
Are the connectors securely
connected?
Go to step 5 Reconnect the
connectors. Go
to step 4.
4 Cycle the power.
Does the error still occur?
Go to step 5. Complete.
5 Replace the Laser Unit (page 8-31).
Does the error still occur?
Replace the
MCU Board
(page 8-59).
Complete.