Phaser 6130 Color Laser Printer Service Manual 8-27
Service Parts Disassembly
11. Release the harness wires from the hooks and retainers in the wire runs
in the Regi Feeder Chute.
Note
Disconnecting the connectors from the photo sensors is usually
easier if you remove the sensor from the chassis first. This may
require further disassembly of the Regi Feeder Chute, including
removal of the Regi Roller and the Feed Roller Shaft. Refer to the
exploded drawings in the parts lists, PL 3.1 on page 9-8 and PL 3.2
on page 9-10.
12. Unplug the connectors from the Regi (P/J 232) and Tray No Paper (P/
J234) sensors.
s6130-220
231
234
233
232
To Next Page
Loading...
