Yamaha 40V - General Torque

2-18
SPEC
E
TIGHTENING TORQUE
GENERAL TORQUE
This chart specifies the torques for tighten-
ing standard fastners with standard clean
dry ISO threads at room temperature.
Torque specifications for special compo-
nents or assemblies are given in applicable
sections of this manual. To avoid causing
warpage, tighten multifastener assemblies
in crisscross fashion, in progressive stages
until the specified torque is reached.
Nut (A) Bolt (B)
General torque
specifications
Nm m•kg ft•lb
8 mm M5 5.0 0.5 3.6
10 mm M6 8.0 0.8 5.8
12 mm M8 18 1.8 13
14 mm M10 36 3.6 25
17 mm M12 43 4.3 31