3-11
INSP
ADJ
E
GENERAL
4. Measure:
● Electrodes gap a
Out of specification → Regap.
Gap:
0.9 ~1.0 mm (0.035 ~ 0.039 in)
5. Tighten:
● Spark plug
NOTE:
Before installing the spark plug, clean the
gasket surface and the plug surface.
NOTE:
If a torque wrench is not available, a good
estimate of the correct torque is a further 1/4
to 1/2 turns b on finger-tightened a spark
plug.
T
R
.
.
Spark plug:
25 Nm (2.5 m • kg, 18 ft • lb)
Grease points
1. Apply:
● Water resistant grease
To Next Page
Loading...
