Yamaha FZ09E - Page 196

air.
14.Measur
e:
• Front fork leg oil level "a"
(from the top of the outer tube, with t
he outer
tube fully compressed and without the fork
sp
rin g)
Out of specification
-> Correct.
15.lnstall:
Level (left)
147 mm (5.8 In)
Level (right)
148 mm (5.8 in)
• Fork sp rin g (Left side) "1"
• Spacer (Left side) "2"
• Locknut (Left side) "3"
• Washer (Left side) "4"
• Cap bolt (Left side) "5"
a
(along with the 0 -ring 1
11
~1'1![§
111
&\•i )
2
4
5 3 ~~
,
YYTTTYTTTYYTTTYTTTYYTTYYTTTYTTTY
a. Remove t he r od pu ll er and rod puller attac h·
men t.
b. Install th e fork sp ri n g.
TIP ---------------
lnstall the fork sp ring with the smaller diameter
"a" fac ing up "A" .
FRONT FORK
-- - A
---- ~
- - - - -1 - '- -- " - ""'
---- - ·- '"'
,_, _ - ~
-
Ja
- - -'<:)
-- - --- ,_ A ·A -' V
-·---- I- - '- .....
------ · '-
c. Insta ll the locknut all the way onto the damper
rod assembly.
d. Insta
ll the rod puller and rod puller attach-
ment.
e. Install the space
r.
f. Install the fork sp rin g compressor.
g. Press down
on th e spacer with th e fork spring
compressor "1".
h. Pu
ll up the rod puller and insta ll t he rod holder
"2" between the locknut "3" and the spacer
"4" .
Rod puller
90890-01437
Universal
damping rod bleeding
tool set
YM·A8703
Rod
puller attachment (M10)
90890-01436
Universal
damping rod bleeding
tool set
YM·A8703
Fork spring compressor
90890-01441
YM-01441
Rod
holder
90890-01434
Damper
rod holder double ended
YM-01434
TIP ---------------
Use th e si de of the rod holder that is marked "B".
1. Remove the rod puller and rod pu ll er at1ach·
ment.
4-56