8.3 Advanced Autotuning
8-29
14.
After confirming that the value displayed in the identified moment of inertia (mass) ratio and the
value displayed in the Pn103: Moment of Inertia Ratio are the same, click Finish.
The following window will appear.
15.
Click OK.
The following window will appear
16.
Click Execute to save the change of Pn103 (Moment of Inertia (Mass) Ratio) to SERVOPACK.
After the saving is finished, the tuning main window will appear.
This completes the moment of inertia (mass) identification procedure.
To Next Page
Loading...
