9.13 EasyFFT
9-33
5.
Click Measurement complete.
6.
If setting the parameters to the values shown in the measurement results, click Result Writing.
(3) Related Parameters
The following parameters are either referenced or automatically changed during execution of EasyFFT.
Do not change the settings of these parameters from the SigmaWin+ or any other means during execution of
EasyFFT.
Parameter Name
Automatic
changes
Pn408 Torque Related Function Switch Yes
Pn409 1st Notch Filter Frequency Yes
Pn40A 1st Notch Filter Q Value No
Pn40C 2nd Notch Filter Frequency Yes
Pn40D 2nd Notch Filter Q Value No
Pn456 Sweep Torque Reference Amplitude No
To Next Page
Loading...
Need help?
General
