YASKAWA T1000V - Page 154

5.5 E: Motor Parameters
154 YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual
Figure 5.35 explains the motor code setting.
Figure 5. 35
Figure 5.35 PM Motor Code
■ E5-02: Motor Rated Power (PM OLV)
Sets the rated power of the motor.
Note: This parameter is not reset when the drive is initialized using A1-03.
■ E5-03: Motor Rated Current (PM OLV)
Sets the motor rated current in amps.
Note: 1. Setting units vary by the maximum allowable motor capacity, which is determined by C6-01 and o2-04. Drives up to 11 kW display a
two-digit value, while drives 11 kW and larger display a single-digit value.
2. This parameter is not reset when the drive is initialized using A1-03.
■ E5-04: Number of Motor Poles (PM OLV)
Sets the number of motor poles.
Note: This parameter is not reset when the drive is initialized using A1-03.
■ E5-05: Motor Stator Resistance (PM OLV)
Set the resistance for each motor phase (not line-to-line resistance). When measuring the resistance manually make sure
to enter the resistance of one phase into E5-05.
Note: This parameter is not reset when the drive is initialized using A1-03.
■ E5-06: Motor d-Axis Inductance (PM OLV)
Sets the d axis inductance in units of 0.01 mH.
Note: This parameter is not reset when the drive is initialized using A1-03.
No. Parameter Name Setting Range Default
E5-02 Motor Rated Power 0.10 to 18.50 kW
Determined by
E5-01
No. Parameter Name Setting Range Default
E5-03 Motor Rated Current
10 to 200% of drive rated
current
Determined by
E5-01
No. Parameter Name Setting Range Default
E5-04 Number of Motor Poles 2 to 48
Determined by
E5-01
No. Parameter Name Setting Range Default
E5-05 Motor Stator Resistance 0.000 to 65.000 Ω
Determined by
E5-01
No. Parameter Name Setting Range Default
E5-06 Motor d-Axis Inductance 0.00 to 300.00 mH
Determined by
E5-01
0000
0: 1800 r/min Series
1: 3600 r/min Series
2: 1750 r/min Series
3: 1450 r/min Series
4: 1150 r/min Series
F: Special Motor
Motor Voltage Class
and Capacity
0: Pico Motor
(SMRA Series)
1: Derated Torque for IPM
Motors
(SSR 1 Series)