YASKAWA T1000V - Page 359

B.3 Parameter Table
YASKAWA ELECTRIC SIEP C710606 44B YASKAWA AC Drive T1000V Technical Manual 359
Parameter List
B
U1-11 Output Terminal Status
Displays the output terminal status.
No output signal
available
–AAA4A
U1-12 Drive Status
Verifies the drive operation status.
No output signal
available
–AAA4B
U1-13 Terminal A1 Input Level Displays analog input A1 level: 100% when input is 10 V. 10 V: 100% 0.1% A A A 4E
U1-14 Terminal A2 Input Level Displays analog input A1 level: 100% when input is 10 V. 10 V: 100% 0.1% A A A 4F
U1-16
Output Frequency after Soft
Starter
Displays output frequency with ramp time and S-curves.
Units determined by o1-03.
10 V: Max
frequency
0.01
Hz
AAA 53
U1-18 OPE Fault Parameter
Displays parameter no. for oPE or Err where error
occurred.
No output signal
available
–AAA 61
U1-19
MEMOBUS/Modbus Error
Code
Displays the contents of a MEMOBUS/Modbus error.
No output signal
available
–AAA 66
U1-24 Input Pulse Monitor Displays the Pulse Train input RP frequency. 32000 Hz A A A 7D
U1-25 Software Number (Flash) Flash ID
No signal output
avail.
–AAA4D
U1-26 Software Number (ROM) ROM ID
No signal output
avail.
–AAA5B
U2: Fault Trace
Use U2 monitor parameters to view fault trace data.
<18>
U2-01 Current Fault Display of the current fault.
No signal output
avail.
–AAA 80
U2-02 Previous Fault Display of the previous fault.
No signal output
avail.
–AAA 81
U2-03
Frequency Reference at
Previous Fault
Displays the frequency reference at the previous fault.
No signal output
avail.
0.01
Hz
AAA 82
U2-04
Output Frequency at
Previous Fault
Displays the output frequency at the previous fault.
No signal output
avail.
0.01
Hz
AAA 83
No. Name Description
Analog Output
Level
Unit
Control
Mode
Addr.
Hex
V/f
OL
V
P
M
Multi-Function
Digital Output (fault)
(terminal MA/MB-MC)
Multi-Function
Digital Output 1
(terminal P1-C1) enabled
Multi-Function
Digital Output 2
(terminal P2-C2) enabled
During run
During zero-speed
During REV
During fault reset
signal input
During speed agree
Drive ready
During alarm
detection
During fault detection
CRC Error
Data Length Error
Not Used
Parity Error
Overrun Error
Framing Error
Timed Out
Not Used