u
Module Communications Connector
The module communications connector port allows the transfer of information to enable turning on and operating drive models
4o0720 to 4o0930 and the harmonic filter module.
Note:
Connect the drive and harmonic filter module before turning on or operating models 4o0720 to 4o0930.
Refer to Drive Standard Connection Diagram (Example: Model 4
o
0720) on page 81 for more information on module
communications connector functions.
n
Module Communications Connector Locations
Connect drive models 4o0720 to 4o0930 to the harmonic filter module using the module communications connector cable
packaged with the harmonic filter module.
Connect one end of the cable to the module communications connector port CN500 of the drive and the other end of the cable
to the module communications connector port CN500 of the harmonic filter module.
Insert both ends of the cable then gently pull the cable to ensure a secure connection.
Drive Models 4o0720 to 4o0930
Figure 3.38 Module Communications Connector Port CN500 Location
3.9 Control Circuit Wiring
112
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual
To Next Page
Loading...
