3.6 Digital Operator and Front Cover
Detach the digital operator from the drive for remote operation or when opening the front cover to install an option card.
NOTICE: Be sure to remove the digital operator prior to opening or reattaching the front cover. Leaving the digital operator plugged into the
drive when removing the front cover can result in erroneous operation caused by a poor connection. Firmly fasten the front cover back into
place before reattaching the digital operator.
u
Removing/Reattaching the Digital Operator
n
Removing the Digital Operator
While pressing on the tab located on the right side of the digital operator, pull the digital operator forward to remove it from
the drive.
Figure 3.20 Removing the Digital Operator
n
Reattaching the Digital Operator
Insert the digital operator into the opening in the front cover while aligning it with the notches on the left side of the opening.
Next, press gently on the right side of the operator until it clicks into place.
Figure 3.21 Reattaching the Digital Operator
u
Removing/Reattaching the Front Cover
n
Removing the Front Cover
Drive Models 2
o
0028 to 2
o
0130 and 4
o
0011 to 4
o
0124
After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover. Pinch in on the tabs
found on each side of the front cover, then pull forward to remove it from the drive.
3.6 Digital Operator and Front Cover
92
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual
To Next Page
Loading...
