n
Reattaching the Terminal Cover
After wiring the terminal board and other devices, double-check connections and reattach the terminal cover. Refer to Wiring
the Main Circuit Terminal on page 106 and Wiring the Control Circuit Terminal on page 110 for details on wiring.
Figure 3.19 Reattaching the Terminal Cover
<1> Connect the ground wiring first, then the main circuit wiring, and finally the control circuit wiring.
3.5 Terminal Cover
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual
91
3
Electrical Installation
To Next Page
Loading...
