u
Subchart A-2: High Performance Operation Using OLV or CLV
Flowchart A2 in Figure 4.10 describes the setup procedure for high-performance with Open Loop Vector Control or Closed
Loop Vector Control, which is appropriate for applications requiring high starting torque and torque limits.
Note: Although the drive sets parameters for the PG encoder during Auto-Tuning, sometimes the direction of the motor and direction of the PG
get reversed. Use parameter F1-05 to switch the direction of the PG so that it matches the motor direction.
4.4 Start-Up Flowcharts
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual
149
4
Start-Up Programming
& Operation
To Next Page
Loading...
