YASKAWA U1000 - Connecting Peripheral Devices; Drive Models 2 O0028 to 2 O0248 and 4 O0011 to 4 O0590

8.3 Connecting Peripheral Devices
Figure 8.1 and Figure 8.2 illustrate how to configure the drive and motor to operate with various peripheral devices.
Refer to the specific manual for the devices shown below for installation instructions.
Note: If the drive is set to trigger a fault output when the fault restart function is activated (L5-02 = 1), then a sequence to interrupt power when
a fault occurs will turn off the power to the drive while the drive attempts to restart. The default setting for L5-02 is 0 (fault output active
during restart).
u
Drive Models 2o0028 to 2o0248 and 4o0011 to 4o0590
Copy Verify Read
LOCK
YASKAWA
JVOP-181
USB Copy Unit
COM ERR
Power
Supply
Surge
Absorber
LED Operator/LCD Operator
Engineering Software Tools
USB
Copy unit
Ground
Ground
Motor
Magnetic
Contactor
(switches to
line power)
USB Cable
(Type-AB)
USB Cable
(Type-AB, sold separately)
PC
Momentary
Power Loss
Recovery Unit
Line
Breaker
(MCCB)
or
Leakage
Breaker
Magnetic
Contactor
(MC)
Zero-phase
Reactor
U1000
U/T1 V/T2 W/T3 R/L1 n1p1 S/L2 T/L3
DriveWizard
DriveWorksEZ
N B1/P
Figure 8.1 Connecting Peripheral Devices to Drive Model 2o0028
8.3 Connecting Peripheral Devices
460
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual