YASKAWA U1000 - Page 366

n
Operation Errors
Table 6.11 Operation Error Displays
Digital Operator
Display
Name Page
oPE01 Unit Capacity Setting Fault 393
oPE02 Parameter Range Setting Error 393
oPE03 Multi-Function Input Selection Error 393
oPE04 Initialization Required 394
oPE05 Initialization Required 394
oPE06 Control Method Selection Error 394
oPE07
Multi-Function Analog Input Selection
Error
394
oPE08 Parameter Selection Error 395
oPE09 PID Control Selection Fault 395
Digital Operator
Display
Name Page
oPE10 V/f Data Setting Error 395
oPE11 Carrier Frequency Setting Error 395
oPE13 Pulse Monitor Selection Error 395
oPE15 Torque Control Setting Error 396
oPE16 Energy Saving Constants Error 396
oPE18 Online Tuning Parameter Setting Error 396
oPE20 PG-F3 Setting Error 396
oPE30 Incorrect Input Voltage Adjustment 396
n
Auto-Tuning Errors
Table 6.12 Auto-Tuning Error Displays
Digital Operator
Display
Name Page
End1 Excessive V/f Setting 397
End2
Motor Iron-Core Saturation
Coefficient
397
End3 Rated Current Setting Alarm 397
End4 Adjusted Slip Calculation Error 397
End5 Resistance Tuning Error 397
End6 Leakage Inductance Alarm 397
End7 No-Load Current Alarm 398
Er-01 Motor Data Error 398
Er-02 Minor Fault 398
Er-03 STOP Button Input 398
Er-04 Line-to-Line Resistance Error 398
Er-05 No-Load Current Error 398
Er-08 Rated Slip Error 399
Er-09 Acceleration Error 399
Digital Operator
Display
Name Page
Er-10 Motor Direction Error 399
Er-11 Motor Speed Error 399
Er-12 Current Detection Error 399
Er-13 Leakage Inductance Error 400
Er-14 Motor Speed Error 2 400
Er-15 Torque Saturation Error 400
Er-16 Inertia ID Error 400
Er-17 Reverse Prohibited Error 400
Er-18 Induction Voltage Error 400
Er-19 PM Inductance Error 400
Er-20 Stator Resistance Error 400
Er-21 Z Pulse Correction Error 401
Er-25
High Frequency Injection Parameter
Tuning Error
401
n
Errors and Displays When Using the Copy Function
Table 6.13 Copy Errors
Digital Operator
Display
Name Page
CoPy Writing Parameter Settings (flashing) 402
CPEr Control Mode Mismatch 402
CPyE Error Writing Data 402
CSEr Copy Unit Error 402
dFPS Drive Model Mismatch 402
End Task Complete 402
iFEr Communication Error 402
ndAT
Model, Voltage Class, Capacity
Mismatch
403
Digital Operator
Display
Name Page
rdEr Error Reading Data 403
rEAd
Reading Parameter Settings
(Flashing)
403
vAEr Voltage Class, Capacity Mismatch 403
vFyE
Parameter settings in the drive and
those saved to the copy function are
not the same
403
vrFy
Comparing Parameter Settings
(Flashing)
403
6.3 Drive Alarms, Faults, and Errors
366
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual