NOTICE: Damage to Equipment. Observe proper electrostatic discharge procedures (ESD) when handling the option, drive, and
circuit boards. Failure to comply may result in ESD damage to circuitry.
Figure 8.4 Remove the Front Covers and Digital Operator
2.
Insert the option (B) into the CN5-B or CN5-C connector (J, K) located on the drive and fasten it using one of the
included screws (C). When connecting only one PG option, use the CN5-C connector. Refer to Table 8.2 for more
information.
Figure 8.5 Insert the Option
3.
Connect the ground wire (G) to the ground terminal (H) using one of the remaining provided screws (C). Connect the
other end of the ground wire (G) to the remaining ground terminal and installation hole on the option (B) using the last
remaining provided screw (C) and tighten both screws to 0.5 to 0.6 N m or (4.4 to 5.3 in lbs).
8.4 Option Installation
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual
463
8
Peripheral Devices &
Options
To Next Page
Loading...
