YASKAWA U1000 - Page 690

No. Name
User
Setting
o2-06
Operation Selection when Digital Operator is
Disconnected
o2-07 Motor Direction at Power Up when Using Operator
o3-01 Copy Function Selection
o3-02 Copy Allowed Selection
o4-01 Cumulative Operation Time Setting
o4-02 Cumulative Operation Time Selection
o4-03 Cooling Fan Maintenance Operation Time Setting
o4-05 Capacitor Maintenance Setting
o4-07 DC Bus Pre-charge Relay Maintenance Setting
o4-11 U2, U3 Initialize Selection
o4-12 kWh Monitor Initialization
o4-13 Number of Run Commands Counter Initialization
o4-19 Power Unit Price
q1-01 to
q6-07
DriveWorksEZ Parameters
r1-01 to
r1-40
DWEZ Connection Parameter 1 to 20 (upper/lower)
T1-00 Motor 1/Motor 2 Selection
T1-01 Auto-Tuning Mode Selection
T1-02 Motor Rated Power
T1-03 Motor Rated Voltage
T1-04 Motor Rated Current
T1-05 Motor Base Frequency
T1-06 Number of Motor Poles
T1-07 Motor Base Speed
T1-08 PG Number of Pulses Per Revolution
No. Name
User
Setting
T1-09 Motor No-Load Current (Stationary Auto-Tuning)
T1-10 Motor Rated Slip (Stationary Auto-Tuning)
T1-11 Motor Iron Loss
T2-01 PM Motor Auto-Tuning Mode Selection
T2-02 PM Motor Code Selection
T2-03 PM Motor Type
T2-04 PM Motor Rated Power
T2-05 PM Motor Rated Voltage
T2-06 PM Motor Rated Current
T2-07 PM Motor Base Frequency
T2-08 Number of PM Motor Poles
T2-09 PM Motor Base Speed
T2-10 PM Motor Stator Resistance
T2-11 PM Motor d-Axis Inductance
T2-12 PM Motor q-Axis Inductance
T2-13 Induced Voltage Constant Unit Selection
T2-14 PM Motor Induced Voltage Constant
T2-15 Pull-In Current Level for PM Motor Tuning
T2-16
PG Number of Pulses Per Revolution for PM Motor
Tuning
T2-17 Encoder Z Pulse Offset
T3-01 Test Signal Frequency
T3-02 Test Signal Amplitude
T3-03 Motor Inertia
T3-04 System Response Frequency
E.3 User Setting Table
690
YASKAWA ELECTRIC SIEP C710636 04D U1000 Industrial MATRIX Drive Technical Manual