7-62
IM AQ6370D-01EN
Setting the Analysis Conditions
1.
Press ADVANCE and then the DATA LOGGING soft key. The soft key menu for
data logging appears.
2.
Press the SETUP soft key. A menu for setting the data logging conditions appears.
When the Logging Item Is WDM
3.
Press the ANALYSIS PARAMETER soft key. The WDM analysis parameter
setting screen appears.
For the operating procedure, see steps 4 to 6 in “When changing the analysis
parameters” of section 7.7.
For parameter descriptions, see section 7.7.
If you change a parameter, the value specified in section 7.7 will also change
(because the parameter is shared).
7.15 Analysis Data Logging
To Next Page
Loading...
Need help?
General
