APPENDIX A STANDARD DEFAULT
PARAMETERS
Default Parameters
Table A-1
Standard Default Parameters Table
Parameter
Parameter
Number
SSI Number Default
Page
Number
User Preferences
Set Default Parameter N/A N/A Restore Defaults
6-5
Parameter Scanning 236 ECh Enable
6-6
User Parameter Pass Through 625 F1h 71h Disable
6-7
Beep After Good Decode 56 38h Enable
6-8
Beeper Tone 145 91h Medium
6-9
Beeper Volume 140 8Ch High
6-10
Suppress Power-up Beeps 721 F1h D1h Do not suppress
6-10
Trigger Modes 138 8Ah Presentation
6-11
Presentation Performance Mode 650 F1h 8Ah Standard
6-12
Time Delay to Presentation Idle Mode 663 F1h 97h 1 Minute
6-13
Time Delay to Presentation Sleep Mode 662 F1h 96h 1 Minute
6-15
Power Mode 128 80h Low Power
6-17
Time Delay to Low Power Mode 146 92h 1.0 Sec
6-17
Picklist Mode 402 F0h 92h Disabled Always
6-19
Decode Session Timeout 136 88h 9.9 Sec
6-19
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
