Zebra DS457 User Manual

CHAPTER 6 USER PREFERENCES
Introduction
This chapter describes each user preference feature and provides the programming bar codes necessary for
selecting these features.
Host Selection
The default serial host is SSI and the default USB host is HID Keyboard Emulation, as these host types provide
more flexibility during integration when configuring the unit via host command. Selecting other host
configurations requires scanning bar code menus and cannot be performed via host programming. See each
host chapter for configuration options for each host type.
Phantom Scan Session
The Phantom Scan Session feature places the system into a known state for two seconds immediately after
the power-up beep sequence in order to decode a parameter bar code without intervention and regardless of
existing settings and mode. This allows you to scan a Set Defaults or other parameter bar code without
triggering the imager or initiating a host scan session in order to return an unresponsive system to its factory
default settings. Aim and illumination are turned off and Phantom Scan exits upon a trigger event, host
command, or successful decode.
NOTE The DS457 automatically switches between USB and serial host interfaces based on the type of cable
attached.
NOTE Selecting one of the Serial Host Types on page 9-5 disables SSI support. To restore SSI support, scan
SSI Host on page 8-9.

Zebra DS457 Specifications

General

Type	Fixed bar code reader
Wavelength	655 nm
Sensor type	-
Scanner type	1D/2D
Optical sensor resolution	752 pixels
Standard interfaces	USB
Connectivity technology	Wired
Input voltage	5 V
Power consumption	450 mA
Safety	ETL, VDE, CETL, EN60950, Ctick, VCCI
Certification	FCC, RoHS
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 50 °C
Cables included	USB, VGA
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	58.4 mm
Width	62 mm
Height	29.2 mm
Weight	111 g