Zebra MC33 Series User Manual

Accessories
169
MC33XX-G Rubber Boot
The rubber boot provides additional protection to the MC33XX-G.
To attach the rubber boot:
1. Slide the top of the MC33XX-G into the top of the rubber boot.
Figure 28 Attach top of Rubber Boot
2. Grasp the bottom of the rubber boot and place over the bottom of the MC33XX-G.
Figure 29 Attach bottom of Rubber Boot
NOTE: To function properly, remove the lower part of the rubber boot or the entire rubber boot before placing in
a charging cradle.

Zebra MC33 Series Specifications

General

Connectivity	USB 2.0, Bluetooth
Touch Panel	Capacitive, glove and wet touch support
Keypad Options	Touchscreen or physical keypad
Scanning	1D/2D barcode scanning
Wireless LAN	IEEE 802.11 a/b/g/n/ac
Operating Temperature	-20° C to 50° C