Using the MC33
68
Performing a Hard Reset
Perform a Hard Reset if the device stops responding. To perform a Hard Reset:
1. Simultaneously press and hold the Power button, 1 and 9 keys for five seconds.
2. The device reboots.
Suspend Mode
The MC33XX goes into suspend mode when the user presses the Power button or after a period of inactivity (set in
the Display settings window).
To wake the MC33XX from Suspend mode, press the Power button. The Lock screen displays. Swipe the screen
up to unlock. If the Pattern screen unlock feature is enabled, the Pattern screen appears instead of the Lock
screen. If the PIN or Password screen unlock feature is enabled, enter the PIN or Password after unlocking the
screen.
Transferring Files with a Host Computer via USB
Connect the MC33XX to a host computer using the USB Charging cable or the 1-Slot USB cradle to transfer files
between the MC33XX and the host computer. See Accessories for more information.
When connecting the MC33XX to a host computer, follow the host computer’s instructions for connecting and
disconnecting USB devices, to avoid damaging or corrupting files.
Transferring Files using Media Transfer Protocol
1. Connect the Rugged Charge/USB Cable to the MC33XX or place the MC33XX into the 1-Slot USB/Charge
Only Cradle. See Accessories for setup information.
2. Pull down the Notification panel and touch USB charging this device.
CAUTION: Performing a hard reset with a microSD card installed in the MC33XX may cause damage or data
corruption to the micro SD card.
All un-saved data is lost after performing a hard reset.
NOTE: If the user enters the PIN, password or pattern incorrectly five times, they must wait 30 seconds
before trying again.
If the user forgets the PIN, password or pattern contact the system administrator.
NOTE Use Media Transfer Protocol (MTP) to copy files between the MC33XX (internal memory or microSD
card) and the host computer.
To Next Page
Loading...
Need help?
General
