66
Data Capture
Introduction
This chapter provides information for capturing barcode data using the internal camera and optional scan
modules and Bluetooth scanner.
The device offers the following data capture options:
• Imager (SE4750-SR 2D, SE4850-ER 2D, SE4770 2D, SE4750DPM, and SE4750DPW).
• Laser Scanner (SE965 1D).
• Bluetooth (RS507/RS507X Hands-free imager, RS6000 Bluetooth Ring Scanner, and DS3678 Digital
Barcode Scanner).
NOTE: DataWedge is installed and enabled on the device by default.
By default, the good decode beep is set to system volume (Notifications). The good decode beep can be
set to another sound (Music and Media), and the volume can be independently controlled.
Integrated Imager
The device with an integrated 2D imager has the following features:
• Omnidirectional reading of a variety of barcode symbologies, including the most popular linear, postal,
PDF417, Digimarc, and 2D matrix code types.
• Advanced intuitive laser aiming cross-hair and dot aiming for easy point-and-shoot operation.
The imager uses imaging technology to take a picture of a barcode, and executes state-of-the-art software
decoding algorithms to extract the barcode data from the image.
Operational Modes
The device with an integrated imager supports two modes of operation, listed below. Activate each mode
by pressing the Scan button.
• Decode mode - The device attempts to locate and decode enabled barcodes within its field of view. The
imager remains in this mode as long as you hold the scan button, or until it decodes a barcode.
NOTE: To enable Pick List Mode, configure in DataWedge or set in an application using a API command.
To Next Page
Loading...
