EasyManuals Logo

Zebra TC8000 User Manual

Zebra TC8000
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #149 background imageLoading...
Page #149 background image
Maintenance and Troubleshooting 7 - 3
Cleaning the TC8000
Housing
Using the alcohol wipes, wipe the housing including the Scan key.
Display
The display can be wiped down with the alcohol wipes, but care should be taken not to allow any pooling of liquid
around the edges of the display. Immediately dried the display with a soft, non-abrasive cloth to prevent streaking.
Scan Exit Window
Wipe the scan exit window periodically with a lens tissue or other material suitable for cleaning optical material
such as eyeglasses.
Power Connector
1. Remove the battery from TC8000.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Rub the cotton portion of the cotton tipped applicator back-and-forth across the connector inside the handle of
the TC8000. Do not leave any cotton residue on the connector.
4. Repeat at least three times.
5. Use the cotton tipped applicator dipped in alcohol to remove any grease and dirt near the connector area.
6. Use a dry cotton tipped applicator and repeat steps 3 through 5.
7. Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away from the surface.
8. Inspect the area for any grease or dirt, repeat if required.
Cleaning Cradle Connectors
Use this procedure to clean the connectors on a cradle:
1. Remove power from the cradle.
2. Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.
3. Rub the cotton portion of the cotton tipped applicator along the pins of the connector. Slowly move the
applicator back-and-forth from one side of the connector to the other. Do not let any cotton residue on the
connector.
4. All sides of the connector should also be rubbed with the cotton tipped applicator.
5. Spray compressed air in the connector area by pointing the tube/nozzle about ½ inch away from the surface.
CAUTION
Do not point nozzle at yourself and others, ensure the nozzle or tube is away from your face.
CAUTION
Do not point nozzle at yourself and others, ensure the nozzle or tube is pointed away from your face.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra TC8000 and is the answer not in the manual?

Zebra TC8000 Specifications

General IconGeneral
Resolution480 x 800 pixels
Storage8 GB Flash
IP SealingIP65
Operating SystemAndroid
Processor1.7 GHz Dual-core
RAM1 GB
Battery Capacity6700 mAh
ConnectivityWi-Fi, Bluetooth
Touch PanelCapacitive
Scanning1D/2D Barcode
Operating Temp-20°C to 50°C
Drop Spec8 ft./2.4 m drop to concrete
Display Size4.0 inches

Related product manuals