EasyManua.ls Logo

Zebra TC8000 - Getting Started; Initial Setup Procedures

Zebra TC8000
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 1 GETTING STARTED
Introduction
This chapter describes the features of the TC8000 and explains how to install and charge the battery and how to
reset the TC8000.
Unpacking
Carefully remove all protective material from the TC8000 and save the shipping container for later storage and
shipping.
Verify that box contains all the equipment listed below:
TC8000
Battery
hand strap
Regulatory Guide.
Inspect the equipment for damage. If you are missing any equipment or if you find any damaged equipment,
contact Support immediately. See Service Information on page xiv for contact information.
Removing the Screen Protection Film
A screen protection film is applied to the TC8000 screen to protect the screen during shipping. To remove the
screen protector, carefully lift the thin film off the display.

Table of Contents

Related product manuals