4 - 10 TC8000 User Guide
3. On the TC8000, touch > > Wi-Fi > > WPS Pin Entry. A dialog box displays with an Pin number.
Figure 4-10 Pin Entry Dialog Box
4. On the router, enter the Pin number. The TC8000 connects to the wireless router.
Wi-Fi Advanced Features
Some additional Wi-Fi settings cannot be accessed from the User Interface. They can be configured by using Wi-Fi
(CSP). Refer to EMDK documentation for the details on the Wi-Fi settings configuration using the Wi-Fi CSP.
•
Auto Time Config - Using this feature, the device can sync up its time with Zebra WLAN infrastructure. This
feature works only when the device is connected to Zebra WLAN infrastructure and the feature is enabled on
the WLAN infrastructure side. Default: disabled.
•
PMKID Caching - Allows the device to skip 802.1x authentication during roaming if it had previously
connected to that AP with a full 802.1x authentication. Default: disabled. Note: disable OKC when enabling
PMKID Caching.
•
Opportunistic Key Caching - Use this feature to skip 802.1x authentication during roaming. The device will
go for full 802.1x authentication for the first time it connects to the network. For subsequent roaming, the
device skips 802.1x authentication. Default: enabled.
•
Cisco Centralized Key Management - Allows the device to skip 802.1x and key-handshake phases during
roaming. This feature is available only when the device is connected to a Cisco infrastructure that supports
Cisco Centralized Key Management (CCKM). Default: enabled.
•
Fast Transition - Fast Transition (FT) is the fast roaming standard, 802.11r. With this feature, the device can
skip 802.1x and key-handshake phases during roam. Default: enabled.
•
Fast Transition Resource Information Container - Allows the device to request TSPEC as part of
reassociation frame exchange. This helps to avoid sending a separate resource request after roaming is
completed. Default: disabled.
•
Power Save - The device can be configured to work in different power save modes:
•Active - Keeps the WLAN radio always in active mode (i.e. power save mode disabled).
• Power save using WMM-PS - This is the default power save mode. Device uses WMM-PS power save
method if the AP is configured to use this. If the AP is not supporting WMM-PS, the device will use PS-Poll
power save method.
• Power save using PS-Poll - In this method, the device will use PS-Poll frames to retrieve buffered frames
from the AP.
• Null Data Power Save - In Null Data Power Save (NDP), the device will stay awake for 100 ms after the
last frame is sent or received. The device will send a Null Data packet with power management bit cleared
to retrieve buffered frames from the AP.
•
802.11k - Using 802.11k, the device can discover neighbor APs and adds support for different types of radio
resource measurements. Default: enabled.
To Next Page
Loading...
Need help?
General
