Zebra TC8000 - DataWedge Application Configuration

3 - 14 TC8000 User Guide
Figure 3-21 Reaching and Bending
DataWedge
Enable DataWedge
To enable DataWedge:
1. Touch > > .
2. Touch Settings.
3. Touch the DataWedge enabled checkbox. A blue checkmark appears in the checkbox indicating that
DataWedge is enabled.
4. Touch .
Disable DataWedge
To disable DataWedge:
1. Touch > > .
2. Touch Settings.
3. Touch the DataWedge enabled checkbox. The blue checkmark disappears from the checkbox indicating that
DataWedge is disabled.
4. Touch .
NOTE DataWedge is enabled by default. Refer to the TC8000 Integrator Guide for DataWedge configuration.