Product Manual - ZMORPH FAB back to table of content
>>
10
During storage, the devices should be oriented in a vertical position with the top facing the direction
marked on the box:
Recommendations for packing:
To transport the device, it is best to protect it with original protective foams; in case of lack of orig-
inal foams, the device should be protected in such a way that free movement of the device in the
transport packaging is not possible.
Secure all moving components (toolhead with X-carriage and worktable with Y-axis) in such a way
that they cannot be moved during transport.
In particular, the glass plate of the worktable should be kept in mind, as it can slide out of the
mounting clips during transport. Make sure that it is secured against ejection.
Recommendations for transportation:
When placing several devices on a pallet, observe the markings on the packaging:
Remember that the edges of the packaging should not protrude beyond the outline of the pallet.
Devices placed in this way on a pallet should be properly packed, bound and then wrapped with foil.
At least two people must be involved in loading and unloading one machine. The packaging should
be lifted by the designated handles on its sides
Protect against
moisture.
Careful, fragile - a
load that can easily
be broken.
Do not roll. Stack up to two
packages one on
top of the other.
Health and safety
To Next Page
Loading...
Need help?
General
