Product Manual - ZMORPH FAB back to table of content
>>
7
2. Health and safety at work
Health and safety
2.1 General safety information
This manual contains warnings and safety information for your Zmorph product. The manual also indicates
situations to which special attention should be paid, and warnings about misuse or neglect of the device. It
is also important to read the material safety data sheets available at the address: zmorph3d.com. Regular
-
structions and software updates, it is recommended that you visit the site support.zmorph3d.com regularly.
Place the unit on a level and clean surface. The device must be secured against overturning, falling from a
height or being knocked down by people moving in the vicinity.
Zmorph Fab Multitool 3D Printer generates very high temperatures during operation, and has easily
accessible moving parts. Caution is advised.
When operating the printer, avoid situations that could cause burns or interfere with the proper
functioning of the device.
of age and persons with reduced manual, motor and psychomotor skills. If the device is operated
by handicapped or elderly people, the Manufacturer recommends using assistance or supervision of
appropriately trained persons.
Do not leave the device unattended during operation, especially when working with the Laser Toolhead.
Periodically check the condition and functionality of the 3D printer to avoid potential malfunctions.
Regularly check the wear and tear of parts in the machine. The list of spare parts can be found in the
spare parts section.
For assistance with technical problems and any maintenance work, please contact the Technical
support at the following address: support.zmorph3d.com
water and other liquids.
Before starting work, ensure that the device is out of reach for children and animals.
Be careful not to drop, hit or shake the device.
This device is not intended to operate in a potentially explosive atmosphere.
chapters.
To Next Page
Loading...
Need help?
General
