Zmorph FAB - Filament Replacement During Printing

Product Manual - ZMORPH FAB back to table of content >>
63
ON OFF AUTO
FAN SPEED
PRINT SPEED
BACK MORE
Go to the LOAD/UNLOAD
menu.
Feed the extruder by following
steps from ‘loading the

12.6 Filament replacement during printing
Single Extruder Toolhead 1.75

the same material as the previous one (PLA/PLA) because the tempera ture of the extruder will be the same

Tap the ‘SETTINGS’ menu. Choose ‘MORE’. Choose ‘CHANGE FILAMENT’
Wait until the extruder stops
printing and lifts itself up.
Tap the ‘TEMPERATURES’
menu and check if the
extruder has the right
temperature.
Tap the ‘LOAD/UNLOAD’
menu.
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
HEAT CHANGE
FILAMENT
SLEEP
MORE SETTINGS
BACK LESS
LOAD/UNLOAD
PLA
ABS
PARK
TOOL
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
BACK
3D printing workow
LOAD/UNLOAD
PLA
ABS
PLA
ABS
PET
CUSTOM
TEMPERATURE
COOL
DOWN
TEMPERATURES
PARK
TOOL
BACK
PAUSE
ABORTSETTINGS
example.gcode
progress 20% 0h34m elapsed